MPA Weight Tuning System

The MPA Weight Tuning System was developed to give the shooter the ability to weight tune their MPA Chassis or rifle. This can be achieved by the addition of the entire weight system, or by using select weights for establishing desired balance points for their setup. If you are looking to improve your ability to spot impacts through weight enhancement, or simply want to change the balance point of your rifle assembly, our weight tuning kit is the ideal addition to your chassis.

The weights can be purchased as a full kit (4 pieces), just the fore end weights (2 pieces), or just the rear weights (2 pieces).

The Complete Weight Tuning Kit for the full size BA Chassis includes the following:

• Steel Enhanced Bag Rider – 1.2 lbs
• Steel Monopod Weight – 1 lb
• Front Fore-end Weight – 1.2 lbs
• Rear Fore-end Weight – 1 lb
• 8 Front Fore-end clamps
• 8 Button Head Cap Screws for the clamps
• Fasteners for Attaching the Bag Rider and Monopod Weight

The Full Size BA Chassis Fore-End Weight kit includes the following:

• Front Fore-end Weight – 1.2 lbs
• Rear Fore-end Weight – 1 lb
• 8 Front Fore-end clamps
• 8 Button Head Cap Screws for the clamps

The Full Size BA Chassis Buttstock Weight kit includes the following:

• Steel Enhanced Bag Rider – 1.2 lbs
• Steel Monopod Weight – 1 lb
• Fasteners for Attaching the Bag Rider and Monopod Weight

The Complete Weight Tuning Kit for the Hybrid Chassis includes the following:

• Steel Enhanced Bag Rider – 1.2 lbs
• Steel Monopod Weight – 1 lb
• Front Fore-end Weight – 0.8 lbs
• Rear Fore-end Weight – 0.7 lb
• 8 Front Fore-end clamps
• 8 Button Head Cap Screws for the clamps

The Hybrid Chassis Fore-End Weight kit includes the following:

• Front Fore-end Weight – 1.2 lbs
• Rear Fore-end Weight – 1 lb
• 8 Front Fore-end clamps
• 8 Button Head Cap Screws for the clamps

The Hybrid Chassis Buttstock Weight kit includes the following:

• Steel Enhanced Bag Rider – 1.2 lbs
• Steel Monopod Weight – 1 lb
• Fasteners for Attaching the Bag Rider and Monopod Weight

Please allow approximately 1-2 weeks for shipment

The fore end weights in the full size kit are NOT compatible with:

• Tikka inlet chassis
• Savage inlet chassis
• Long action chassis
• Older style chassis: If your chassis looks like the one shown in the image (pay close attention to the radius rib pictured), then it will work with the for end weights. Please keep in mind we will be adding the older chassis configuration to our offering, so please check back often. 

Both rear weights are compatible with all our chassis. Please contact MPA if you’re unsure whether your chassis is compatible with this item and we will be happy to assist you. 

The Hybrid Chassis Weight Kits fits all MPA Hybrid Chassis. 

Made in the USA